Teltonika protocol updated:
Teltonika protocol updated: Freezer AVL_IDs added for FMB640, FMC640 and FMM640 devices.
Mapping of AVL_IDs to flespi parameters is below:
Mapping for Freezer IO parameters is updated.
minor update in parsing 875 flag for GH5200 device: if AVL ID 875 length is 14 symbols then it means that 875 contains not MAC address but IMEI of violating device, thus it would be stored in proximity.violation.ident parameter.
New settings added for Teltonika TST100, Configuration tab: Scooter speed limits for Normal, Eco and Sport modes.
Reset device setting added to Teltonika TST100, TMT100, TFT100 and GH5200 devices, Actions tab.
Setting sends cpureset command to the device.
New setting added for Teltonitka FMC130: Network Ping, Connectivity tab.
Network Ping Timeout setting, Connectivity tab, is added for Teltonika FMB120 and FMB920 devices.
Teltonika devices FMB130, FMC130, FMU130 and FMM130 now have a possibility to configure 3 digital outputs (at Input/Output settings tab):
Manual CAN I/O (AVL IDs 900 - 930) are added for Teltonika TFT100.
They are registered as 8-byte hex string into flespi parameters can.data.frame.1 - can.data.frame.30 respectively.
AVL ID 381 Ground Sense is supported for Teltonika protocol.
It's registered as a boolean parameter negative.input.status: true - negative input is connected to the ground, false - not connected.
Several action settings added for FMB device series.
setdigout action to manage device outputs with specifying timeout and speed limit
New devices added: Teltonika FMB002 and Teltonika FMB003
In one week, 11 January 2021, 11:00 UTC, Teltonika protocol will be upgraded to new parsing engine.
At the moment flespi team performs extensive testing to avoid any bugs and mismatches after the upgrade.
baja Teltonika protocol implementation upgraded to new parsing engine.
New settings added for Teltonika TST100, TFT100, GH5200 and TMT250 devices:
Permanent Link and Network Ping Timeout, Connectivity tab:
MSP500 device type added
Motion Detection Source (param ID 100) setting marked as deprecated is removed.
door.open.status parameter is parsed as bitmask to detect:
can.driver.door.status - front left door is opened
can.passenger.door.status - front right door is opened
can.rear.left.door.status - rear left door is opened
can.rear.right.door.status - rear right door is opened
can.hood.status - hood is opened
can.trunk.status - trunk is opened
bugfix: can.control.module.voltage conversion from millivolts to volts added
Some of Teltonika Routers can send position data using Codec 8. The devices added: