Concox protocol has advanced support level in flespi telematics hub.
New settings added for Concox GT06N device:
Concox AT6: fixed parsing of the following settings:
One more setting parsing is fixed today for Concox AT6 device:
New configuration settings added for the Concox GT08 device, tab Tracking:
Concox protocol updated: GT03A: timezone setting parsing fixed.
we've added a logic to correctly parse wrong timestamps caused by GPS Rollover problem
This problem is caused because GPS date is defined by 10-bit week number which results to max 1024 number. So when this number overflows to 0 then tracker (with firmware algorithms not covering this) starts to send time as it is in the beginning of the 1024 week period which is August 21, 1999.
Concox protocol updated: JV200: timestamp parsing fixed: timezone shift is not applied.
Concox timestamp parsing fixed: timezone shift is not applied for the following devices:
New device supported for concox protocol: Concox JC200
Concox protocol is updated:
Protocol number 0xAA is supported in concox protocol. Text payload that is contained in 0xAA packet is saved into payload.text parameter.
Applicable for Concox JC200
New settings are added for Concox WeTrack2 device:
See WeTrack2 User Manual for more details.
Concox protocol updated: protocol number byte is now stored as protocol.number parameter.
New device type added: Concox AT5
Concox AT5: battery.level parameter added
New settings added for Concox JC200 device, Actions tab:
Concox JC200: several settings were deleted because they didn't worked with JC200 properly:
Please contact us in support chat if you need these or any other settings to be implemented in flespi telematics hub.
Concox protocol updated: implemented Transparent transmission protocol (protocol number 0x9B) for receiving the data from external devices connected to RS232.
Applicable for Concox X3 device.
Concox protocol updated: parameter oil.electric.connection.status is renamed to engine.blocked.status.
Both old and new parameters are registered now, old parameter will be removed 31-jan-2020.
Concox protocol updated: old parameters removed after renaming.